Chapter 4 - Digitizer Manager Image Capture

Allow users to capture the images of the paper patterns and save them in the computer.

- Support Canon EOS Series

2. The shooting distance need to be more than 110cm.

3. System requirement and recommended hardware specification.

4. Accept V notches tailoring on the pattern (Not accept other painting notches and inner line on the pattern). 5. Can not read multiple patterns drawing in single paper.

- Set the power switch to [ON] and set the Mode Dial to (Scene Intelligent Auto) >
- Connecting the camera to the PC

3. The camera is connected to PC successfully when this window pops up

4. Keep your camera and pattern paper parallel, with a distance more than 110 cm.

- Open Digitizer Manager, click menu [Options] - [Calibration]. >
- Enter original position in X, Y and click calibration.

  - Pattern Paper must be placed inside the frame from camera preview
  - Keep pattern X, Y axis parallel to the X, Y axis in camera preview.

3. Calibration Completed → OK.

4. Click menu [File] - [Take Picture]

5. Lay a white paper on checker board paper, put patterns on the paper. Click [OK]. Check patterns in your job list.

6. Open Pattern Design Application, click menu [File] - [Open Digitizer…].

7. Select the “Job List” you want, click [OK] button.

8. Now you can design your patterns in Pattern Design.