====== Chapter 4 - Digitizer Manager Image Capture ======

> Allow users to capture the images of the paper patterns and save them in the computer.

===== Supported Camera And System Requirement =====

>   - Support Canon EOS Series

> {{en:utilities:digitizer_manager:image_capture:capture_image22.png|capture_image22}} 2. The shooting distance need to be more than 110cm.

> {{en:utilities:digitizer_manager:image_capture:capture_image13.png|capture_image13}} 3. System requirement and recommended hardware specification.

> {{en:utilities:digitizer_manager:image_capture:image003.png|image003}} 4. Accept V notches tailoring on the pattern (Not accept other painting notches and inner line on the pattern). 5. Can not read multiple patterns drawing in single paper.

===== Setup The Camera =====

==== How to setup the camera ====

>   - Set the power switch to [ON] and set the Mode Dial to {{en:utilities:digitizer_manager:image_capture:capture_image9.png|capture_image9}} (Scene Intelligent Auto) > {{en:utilities:digitizer_manager:image_capture:capture_image10.png|capture_image10}}
>   - Connecting the camera to the PC

> {{en:utilities:digitizer_manager:image_capture:capture_image11.png|capture_image11}} 3. The camera is connected to PC successfully when this window pops up

> {{en:utilities:digitizer_manager:image_capture:capture_image12.png|capture_image12}} 4. Keep your camera and pattern paper parallel, with a distance more than 110 cm.

{{en:utilities:digitizer_manager:image_capture:capture_image13.png|capture_image13}}


===== Capture Image =====

==== How to capture image by using Digitizer Manager ====

>   - Open Digitizer Manager, click menu [Options] - [Calibration]. > {{en:utilities:digitizer_manager:image_capture:capture_image14.png|capture_image14}}
>   - Enter original position in X, Y and click calibration.
    - Pattern Paper must be placed inside the frame from camera preview
    - Keep pattern X, Y axis parallel to the X, Y axis in camera preview.

>> {{en:utilities:digitizer_manager:image_capture:capture_image15.png|capture_image15}} 3. Calibration Completed -> OK.

> {{en:utilities:digitizer_manager:image_capture:capture_image16.png|capture_image16}} 4. Click menu [File] - [Take Picture]

> {{en:utilities:digitizer_manager:image_capture:capture_image17.png|capture_image17}} 5. Lay a white paper on checker board paper, put patterns on the paper. Click [OK]. Check patterns in your job list.

> {{en:utilities:digitizer_manager:image_capture:capture_image18.png|capture_image18}} 6. Open Pattern Design Application, click menu [File] - [Open Digitizer…].

> {{en:utilities:digitizer_manager:image_capture:capture_image19.png|capture_image19}} 7. Select the “Job List” you want, click [OK] button.

> {{en:utilities:digitizer_manager:image_capture:capture_image20.png|capture_image20}} 8. Now you can design your patterns in Pattern Design.

{{en:utilities:digitizer_manager:image_capture:capture_image21.png|capture_image21}}