Differences

This shows you the differences between two versions of the page.

--- en:marker:marker_design_ch3_tool [2025/07/14 04:10] – [tool_image011 Text] administrator
+++ en:marker:marker_design_ch3_tool [2025/07/14 04:13] (current) – [tool_image013 Convert Notch] administrator
@@ Line 257: / Line 257: @@
-===== tool_image010 Fill a Hole =====
+===== Fill a Hole =====
 {{en:marker:tool:tool_image010.png|tool_image010
 }}
@@ Line 273: / Line 273: @@
 ===== Text =====
-{{en:marker:tool:tool_image0011.png|tool_image0011
+{{en:marker:tool:tool_image011.png|tool_image011
 }}
@@ Line 299: / Line 299: @@
-===== tool_image012 Ruler =====
+===== Ruler =====
+{{en:marker:tool:tool_image012.png|tool_image012
+}}
 > The Ruler tool allows you to measure the distance between any two points.
@@ Line 314: / Line 317: @@
 > Users can keep the dialogs open and take measure on another piece. Two dialogs appear and allow users to compare the measurement.
-===== tool_image013 Convert Notch =====
+===== Convert Notch =====
+{{en:marker:tool:tool_image013.png|tool_image013
+}}
 > The Convert Notch tool enables you to convert one or more notches on pieces that have already been placed in the Fabric Simulation Area.